Name:   Manual Heat Transfer Machine

parameter:

Voltage:110v  220v  380V

power:1800W

Temperature range:0-399¡æ

Time range:0-999sec

Work table size:38*38  40*60(cm)

Casing size:72*44*39  75*65*42    (cm)

Avoirdupois:30kg 40kg

Characteristic ;
1..digital control system PID Micro-computer controller .high precision ( 1¡æ)
2. all digital time show , high accuracy .
3. Heat Tube integrate with Heat Board in one unit , safety, durable, heat distribute uniformity. and strong heat exchange
4. Soleplate furnish can bear high temperature froth silica gel, can bear 400 ¡æ and doesn’t distortion.
5. adjustable pressure ,easy operation.
6. beautiful appearance, small and exquisite cubage ,effective improve working efficiency .

Operation:

1.Plug the power and turn on the general switch and the indication light bright.

2.close the pressure handle ( adjust suitable pressure )

3. Adjust the temperature regulator to suitable temperature .when temperature reaches the set point, the indication light will go out .then can be start to work.

4. Adjust timer button to a suitable time,

5..put the hat on the heating plate, then cover with the transfer paper on the hat,( please note the obverse and reverse of the paper).press the handle down until the end .

6.the buzzer will alarm when time is over , at this time you should take the handle up to the original place

Notice:

1.must have a suitable and firm earth wire for protection .

2. In order to avoid handle distortion , please don’t force the handle more than 30 kg.

3..please note the obverse and reverse of the paper when cover the heat transfer paper.

4..if want to tear off the transfer paper in the cold condition , please wipe the paper by brush first ,  wait 5-10 second , then tear off the paper

5..if want to tear off the transfer paper in the hot condition. please tear it off immediately after printing

6..A suitable time, temperature and pressure are all important factors to a successful transfer printing; and the thickness of the clothes, the material and the kind of the transfer paper can also influence the effect.

7..we are provide all kind of heat transfer paper

8.Please test for print before produce as batch

Maintenance:

 1, Pressure: if the pressure is not enough or too much, you can loose the pressure screw to adjust it. Please close the adjust lock screw firm after adjusted.
2., Temperature: if the temperature was reached the set point but the heating plate does not work. Please Check 

temperature controller was connect the power or not while confirm whether the electrical source broken or not .

( temperature controller needs about 15minutes to reach 180 centigrade from 0 centigrade ).

3.Time: when time is over but the buzzer does not alarm or alarm endlessly, please check the micro-switches point whether have a suitable distance. Please adjust to the suitable position if unconventionality .

4.when hold the handle and press it down to the bottom ,but it auto rise up when loose the hand , please adjust the knob to down .

5.please contact us if have any quality problem.

Alternate View